Ricoh S-P2 Service Manual page 91

Selects the number of rotations for the bypass feed roller when the paper type is set for
"Transparencies". Change this setting to "2" if jams occur frequently when feeding
transparencies from the bypass tray.
1 = 1 rotation, 2 = 2 rotations
Fusing Start DFU
[Roller Turn / Normal]
Roller Turn: Warms up the fusing unit for 20 sec. just after the power switch has been
1910
turned on or when the machine warms up from energy saver mode.
Normal: There is no 20 sec. warm-up period. However, just after the main power switch
is turned on, the motor rotates to clean the drum.
Normal, Roller Turn
Curl Control
Thin paper has a tendency to jam or wrinkle, especially during duplex printing. When
this SP code is switched on:
• The machine ignores the fusing temperature set for SP1105.
1911
• When the machine is powered on or recovers from the low power mode the machine
requires about 20 sec. to warm up (this is longer than normal).
[0 to 1/0/1]
0: Normal
1: Curl Control
1913 SC559 Detect
This SP setting determines whether SC559 is issued after three paper late jams occur in
the fusing unit. After this SP code is turned on, a counter monitors the number of paper
late jams that occur in the fusing unit. After the 3rd occurrence of a fusing jam, SC559 is
issued and the machine cannot be used until the service technician releases the error.
Note: Switching the machine off/on does not reset this jam counter. The counter is reset
after the cause of the jam has been removed and a sheet of paper successfully passes
the fusing exit sensor.
[0 to 1/0/1]
0: No
1: Yes
Printer Engine Service Mode
Fusing Jam SC Setting
5
89