Ricoh S-P2 Service Manual page 138

5. Service Tables
7993 Total counter
Displays the engine total counter. It counts up for all prints, including service reports.
5
SP8XXX: Data Log 2
The SPs in this group are prefixed with a letter that indicates the mode of operation. The mode of operation
is referred to as an 'application'. Before reading the Group 8 Service Tables, make sure that you understand
what these prefixes mean.
Prefix Application
T: Total
P: Print
O: Other
Group 8 SP codes are limited to 17 characters, forced by the necessity of displaying them on the small
LCDs of printers and faxes that also use these SPs.
• All of the Group 8 SPs are reset with SP5 801 1 Memory All Clear.
8381 T:2-2-01
8384 P:2-2-01
136
• The value is read from the AIO ID Chip.
• The number displayed indicates as a percentage the
amount of time remaining for the OPC based on the
number of drum rotations.
• If the cartridge is not installed, if the AIO is not set
properly, or if the front door is open, no value will be
displayed because the machine cannot communicate
with the AIO.
Important Note: This SP reads only the engine information.
This information is not sent to the controller.
What It Means
Grand total of the items counted for all applications (C, F, P, etc.).
Totals (pages, jobs, etc.) executed for each application when the job
was not stored on the document server.
Other applications (external network applications, etc.). Refers to
network applications such as Web Image Monitor. Utilities
developed with the SDK (Software Development Kit) are also
counted.
These SPs count the number of pages printed by the customer. The counter
for the application used for storing the pages increments.
[0 to 9999999/0/1]