Table of Contents
Advertisement
Henny Penny
2-1.
INTRODUCTION
2-2.
TEST INSTRUMENTS
2-3.
REMOVING THE
CONTROL PANEL
593
SECTION 2. MAINTENANCE
This section provides procedures for checking and replacement of the
various parts used within the unit. Before replacing any parts, refer to
Section 1, Troubleshooting. It will aid you in determining the cause of a
particular malfunction.
You may use two test instruments to check the electric components.
• A continuity light.
• An ohmmeter.
When the manual refers to the circuit being closed, the continuity light
will be illuminated or the ohmmeter should read zero (0) unless other-
wise noted.
When the manual refers to the circuit being open, the continuity light
will not illuminate or the ohmmeter will read one (1).
A continuity light cannot be used to check coils or motors.
To replace parts located inside the fryer, you will need to remove the
control panel. The following steps provide the correct procedure.
To avoid electrical shock or property damage, move the
power switch to "OFF" and disconnect main circuit breaker,
or unplug cord at wall receptacle.
1. Remove the decorative strips, located on each side of the control
panel, by removing the screw located on the bottom of each
decorative strip.
Model OE-100
SHOCK HAZARD
2-1
Advertisement
Table of Contents
