So-Dimm Installation; Figure 4-1: So-Dimm Installation - IEI Technology KINO-CV-D25501 User Manual

KINO-CV-D25501/N26001 SBC
Before and during the installation of the KINO-CV-D25501/N26001 DO NOT:

DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.

DO NOT use the product before verifying all the cables and power connectors
are properly connected.

DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.

4.3 SO-DIMM Installation

To install a SO-DIMM, please follow the steps below and refer to Figure 4-1.

Figure 4-1: SO-DIMM Installation

Step 1: Open the SO-DIMM socket handles. Open the two handles outwards as far as
they can. See Figure 4-1.
Step 2: Align the SO-DIMM with the socket. Align the SO-DIMM so the notch on the
memory lines up with the notch on the memory socket. See Figure 4-1.
Step 3: Insert the SO-DIMM. Once aligned, press down until the SO-DIMM is properly
seated. Clip the two handles into place. See Figure 4-1.
Page 49