Unpacking; So-Dimm Installation - IEI Technology KINO-PVN-D5251 User Manual


Turn all power to the KINO-PVN-D5251/D4251 off:
o
When working with the KINO-PVN-D5251/D4251, make sure that it is
disconnected from all power supplies and that no electricity is being fed
into the system.
Before and during the installation of the KINO-PVN-D5251/D4251 DO NOT:

Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.

Use the product before verifying all the cables and power connectors are
properly connected.

Allow screws to come in contact with the PCB circuit, connector pins, or its
components.

4.3 Unpacking

When the KINO-PVN-D5251/D4251 is unpacked, please check all the unpacking list items
listed in Chapter 3 are indeed present. If any of the unpacking list items are not available
please contact the KINO-PVN-D5251/D4251 vendor reseller/vendor where the
KINO-PVN-D5251/D4251 was purchased or contact an IEI sales representative.

4.4 SO-DIMM Installation

SO-DIMM is a critical component of the KINO-PVN-D5251/D4251. If it is not installed the
KINO-PVN-D5251/D4251 cannot run.
Page 40
KINO-PVN-D5251/D4251/ Mini ITX SBC