HYPER-AL SBC
4.3 SO-DIMM Installation
To install an SO-DIMM, please follow the steps below and refer to Figure 4-1.
Figure 4-1: SO-DIMM Installation
Step 1:
Locate the SO-DIMM socket. Place the board on an anti-static mat.
Step 2:
Align the SO-DIMM with the socket. Align the notch on the memory with the
notch on the memory socket.
Step 3:
Insert the SO-DIMM. Push the memory in at a 20º angle. (See Figure 4-1)
Step 4:
Seat the SO-DIMM. Gently push downwards and the arms clip into place. (See
Figure 4-1)
4.4 M.2 Module Installation
To install an M.2 module, please follow the steps below.
Step 1:
Locate the M.2 module slot. See Chapter 3. Remove the on-board retention
screw.
Step 2:
Line up the notch on the module with the notch on the slot. Slide the M.2 module
into the socket at an angle of about 20º (Figure 4-2).
Page 39