Mitsubishi Electric MR-J4 Instruction Manual page 662

18. MR-J4-03A6 SERVO AMPLIFIER
2) Inserting wire
When using solid wire, insert the wire to the end. When using stranded wire, insert the wire to the
end with pushing down the release button with a small flat head screwdriver, etc.
The following show a connection example when using stranded wire to the CNP 1 connector.
(c) Mounting connector
1) Mounting
Fit the CNP1 connector when the servo amplifier is fixed. While pushing the connector, make
sure that the connector is locked to the top and bottom of the socket. After that, check that the
connector cannot be pulled out.
Refer to the following example for a status of lock.
2) Disconnection
Pull out the CNP1 connector after unlocking the top and bottom of the connector.
Release button
Stranded wire
Lock hook
Locked
Good example
(Both are locked.)
18 - 21
Locked
Locked
Unlocked
Bad example
(Bottom is not locked.)