Junction Terminal Block Mr-Tb50 - Mitsubishi Electric MR-J4 Instruction Manual

Servo amplifers mr-j4-_a_(-rj), mr-j4-03a6(-rj) melservo-j4

Hide thumbs Also See for MR-J4:

Table of Contents

11. OPTIONS AND AUXILIARY EQUIPMENT

11.6 Junction terminal block MR-TB50

Always use the junction terminal block (MR-TB50) with the option cable (MR-J2M-CN1TBL_M) as a set.

Ground the option cable on the junction terminal block side with the cable clamp fitting (AERSBAN-

ESET). For the use of the cable clamp fitting, refer to section 11.14, (2) (c).

(2) Terminal labels

Use the following junction terminal block labels. This label is supplied with the junction terminal block

(3) Dimensions

1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 3133

2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32

Servo amplifier

Position control mode

Speed control mode

Torque control mode

35 37 39 41 43 45 47 49

34 36 38 40 42 44 46 48 50

Junction terminal block

Junction terminal

(MR-J2M-CN1TBL_M)

Terminal screw: M3.5

Applicable wire: 2 mm

Crimp terminal width: 7.2 mm or less.

Show Quick Links

Table of Contents