SettNg Values N Tenths Of UnTs Above 100 - Lenze SCL series Installation And Operaion Manual

Use the  and  buttons to scroll to the desred parameter number . In the example below,
Parameter 19 s beng dsplayed, whch s the ACCELERATION TIME of the drve:
Use  and  to scroll to the desred
parameter number (the example s
Parameter 19 - ACCELERATION
TIME)
Once the desred parameter number s found, press the Mode button to dsplay the present
parameter settng . The upper rght-hand decmal pont wll begn blnkng, ndcatng that
the present parameter settng s beng dsplayed, and that t can be changed by usng
the  and  buttons .
Press Mode to dsplay present
parameter settng (example set-
tng s 20 .0)
Upper rght decmal pont blnks
Use  and  to change settng
(example settng changed to
30 .0)
Press Mode to store new settng
Pressng Mode wll store the new settng and also ext the PROGRAM mode . To change
another parameter, press the Mode key agan to re-enter the PROGRAM mode (the
parameter menu wll be accessed at the parameter that was last vewed or changed before
extng) . If the Mode key s pressed wthn two mnutes of extng the PROGRAM mode,
the password s not requred access the parameters . After two mnutes, the password
must be entered n order to access the parameters agan .
13.1 Setting Values in Tenths of Units Above 100
Parameter settngs and the keypad speed command can always be adjusted n tenths of
unt ncrements from 0 .0 to 99 .9 . Above 100 however, values can be set n whole unts or
tenths of unts, dependng on the settng of Parameter 16 - UNITS EDITING .
If Parameter 16 - UNITS EDITING s set to WHOLE UNITS (02), parameter values and
the keypad speed command can only be adjusted by whole unt ncrements above 100 .
For example, Parameter 19 - ACCELERATION TIME could not be set to 243 .7 seconds .
It could only be set to 243 or 244 seconds . Lkewse, the keypad speed command (set
usng the  and  buttons) could not be set to 113 .4 Hz . It could only be set to 113 or
114 Hz .
25 SM01M