Lenze SCL Series Instructions

SCL/SCM SERIES REMOTE KEYPAD INSTRUCTIONS
(Manual Number: KM01C)
The SCL/SCM Series Remote Keypad option (844-240) allows the SCL/
SCM Series drive to be programmed and controlled from up to 8 feet away
(typically from the front of the enclosure that houses the SCL/SCM drive).
When properly mounted, the remote keypad is rated up to NEMA 4X.
In addition to the functions available on the front of the SCL/SCM drive,
the remote keypad has Start/Stop and Forward/Reverse functions.
Note:
The Remote Keypad option will only work with SCL/SCM drives that
have parameter version "320" or higher. The parameter version appears
momentarily on the drive display when it is powered up, and also appears
on a small label on the drive's heatsink.
WARNING!
If OEM mode is selected (using Parameter 48), and if the OEM Default
settings for Parameters 11, 12, and 14 are not "13", "21" and "02"
respectively, the remote keypad will be disabled and the STOP key
WILL NOT work. Refer to the SCL/SCM Installation and Operation
Manual for more information on OEM Default settings.
1. PARTS LIST
The SCL/SCM Remote Keypad kit includes the following parts:
(1) Remote Keypad
(2) Self-tapping Mounting Screws
(1) Eight foot cable
Note:
The supplied cable is unshielded and can only be used in low-noise
environments. In high-noise environments, use Belden 9842, Carol
C4842, or equivalent (24 gauge minimum) wire only. The maximum
cable length that can be used is 8 feet.
3. MOUNTING THE REMOTE KEYPAD
The diagram below illustrates how to mount the remote keypad to a panel.
Use the template in Section 2 to mark the location of the mounting holes
on the panel.
PANEL
GASKET
(1) Gasket
(1) Instruction Sheet
MOUNTING
SCREWS
REMOTE
KEYPAD
Lenze Americas • 630 Douglas Street • Uxbridge, MA 01569 • USA
Sales: (800) 217-9100 • Service: (508) 278-9100 • www.lenzeamericas.com
2. SCL/SCM REMOTE KEYPAD TEMPLATE
NOTE: Verify dimensions on printed page before using as a template.
Hold this page against the panel where the remote keypad is to be
mounted, and use a center punch to mark the location of the three holes.
The dotted line is the outline of the remote keypad.
UP
1.32"
1.57"
1.38" to 1.5" hole
Max Depth = 0.72"
4. WIRING CONNECTIONS
WARNING!
Improper wiring may result in damage to the Remote Keypad. Keep
the remote keypad cable away from power wiring.
The Belden and Carol cables specified consist of two twisted pairs.
Make sure one twisted pair is used for connections to 13B and 13E and
the other is used for connections to 11 and 2. Do not mix connections
between twisted pairs
Note:
The supplied cable can be used for distances up to 8 feet in low-
noise environments. For distances up to 100 feet, or in high-noise
environments, use Belden 9842, Carol C4842, or equivalent (24 gauge
minimum) wire only.
2
1 5 6
Cable included with kit
does not have a shield
REMOTE KEYPAD
(BACK VIEW)
1/8" hole
3.38"
1/8" hole
2.19"
11 13A 13B 13E
UP
13B
13E
11
2
13360122
25
KM01C