Universal Robots UR10 Service Manual page 25

Elbow counterpart – Elbow joint: assemble
For details and photos please see:
1. Gently insert Elbow joint with screws and washers into the Elbow counterpart.
2. Make sure the washers are fully inserted and flush against the head of the bolt (this is important)
before gently twisting the parts in opposite directions until a mechanical stop is met.
3. Tighten the 10 screws lightly, and then tighten
4. Slide the grey Teflon ring in place and gently put back the flat ring on top of the Teflon ring.
5. Mount the alignment screw and tighten with
6. Reconnect connectors as illustrated.
Twist the communication cable
7.
(To reduce electrical noise in the system)
8. Mount blue lid on Elbow joint and tighten with
9. Proceed to chapter
All rights reserved
3.1.4 General guidance to separate joint from counterpart
1.5 to 2 full rounds before it is connected.
3.1.16 Dual Robot calibration
in cross order with 2.6-3.0Nm.
0.4Nm.
0.4Nm.
for calibrating the robot.
25 Servicemanual_UR10_en_3.1.3