Protective Stop - Universal Robots UR10 Service Manual

5.3.3 Protective stop

Protective Stop
Payload and tcp settings in Installation\TCP
Configuration must correspond with actual tool.
Are settings incorrect?
Is center of mass very different from tcp point?
Are waypoints positioned very close to cylindrical
area around base of robot where robot can not
operate?
Is robot moving with excessive speed or
accelerating very hard?
Press free drive button on back of TP and check
the free drive function of all joints > observe any
abnormal friction or behavior observed?
Contact distributor from where robot has been
purchased
All rights reserved
NO
NO
NO
NO
NO
Read also article 18939 on the support site
www.universal-robots.com/support
YES
YES
YES
YES
YES
96
Adjust payload and tcp
settings
Adjust center of mass in the
TCP tap or using script code
set_payload()
Adjust waypoints away
from this area or reduce
speed/acceleration
Reduce speed or
acceleration
Inspect joint with abnormal
behavior, joint might have
mechanical failure
Servicemanual_UR10_en_3.1.3