Universal Robots UR10 Service Manual page 23

With cb3.0/3.1-controller
Hide thumbs Also See for UR10:
Table of Contents

Advertisement

Upper arm – Shoulder joint: Assemble
For details and photos please see:
1. Gently insert Shoulder joint with screws and washers into the upper arm.
2. Make sure the washers are fully inserted and flush against the head of the bolt (this is important)
before gently twisting the parts in opposite directions until a mechanical stop is met.
3. Tighten the 10 screws lightly, and then tighten
4. Gently put back the gasket.
5. Mount the alignment screw and tighten with
6. Connect ESD wristband
7. Reconnect wires correctly.
Twist the communication cable
(To reduce electrical noise in the system)
8. Mount blue lid on Shoulder joint and tighten with
11. Proceed to chapter
All rights reserved
3.1.4 General guidance to separate joint from counterpart
1.5 to 2 full rounds before it is connected.
3.1.16 Dual Robot calibration
in cross order with 8.0Nm.
0.4Nm.
0.4Nm.
for calibrating the robot.
23
Servicemanual_UR10_en_3.1.3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents