Initialization; Configuration - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Central Devices
10.7

Initialization

Initialize a multi CCU system as follows:
1 Initialize each CCU and all of its devices
(refer to section 8.7).
2 For each CCU, select a unique multi CCU slave, and
change the mode from "single" to "multi".
(refer to table 8.31, menu item 7I Multi mode).
Note
You can only change the multi CCU slave ID
when the CCU is in single mode.
10.8

Configuration

10.8.1 Microphone modes
This information is the same for the network controller
and the CCU (refer to section 8.8.1).
10.8.2 Audio routing modes
10.8.2. 1 Introduction
You can set the audio routing of audio input 4 and
audio output 4 with the 7G Routing I/O 4 menu item
(see section 10.10.11). The functions of audio inputs 1,
2, and 3 and audio outputs 1, 2, and 3 of the network
controller cannot be changed:
• The signal on audio input 3 is added to the floor
signal.
• The signal on audio output 1 is suitable to connect
the system to an external public address system. The
network controller does not set the volume level,
bass, and treble.
• The signal on audio output 2 is suitable to connect
the system to a recorder.
• The signal on audio output 3 is suitable to connect
the system to an external public address system and
contains the floor signal, which is sent to the delegate
loudspeakers. The network controller sets the
volume level, bass, and treble.
10.8.2.2 Floor
In the Floor mode, audio output 4 of the network
controller transmits the same signal as output 1 (refer to
figure 10.9). In the Floor mode, the signal on audio input
4 of the network controller is added to the floor signal.
Bosch Security Systems | 2007-02 | 9922 141 70525
C
4<
C
C I
I
DCN-SW
+
DCN-CCU
C
+
figure 10.9: Floor
en | 85
3
4
4
2
1
3
Legend
C Contribution devices
I Interpretation devices
Optical network
+
Chime