Bosch DCN Next Generation Installation & User's Instructions page 248

DCN Next Generation | Installation and User Instructions | Installation Devices
15 Close the tool to hold the cable and pull the 'trigger'
to cut the optical fiber (refer to figure 45.18).
figure 45. 1 8: Cutting a fiber (3)
16 Repeat steps 14 and 15 for the other plastic optical
fiber in the cable. Both fibers now have the correct
length.
17 Put one of the optical fibers into the front part of the
POF cutter/stripping tool (tool 6, refer to figure
45.19).
figure 45. 1 9: Stripping a fiber
Bosch Security Systems | 2007-02 | 9922 141 70525
18 Close the tool and pull the fiber out to remove the
sheath.
Note
Do not forget to remove the piece of sheath
from the tool.
19 Repeat steps 17 and 18 for the other fiber in the
cable. Refer to figure 45.20 to see the result of this
part of the cable-connector mounting procedure.
A
figure 45.20: Stripped optical fibers
en | 248
B