Bosch DCN Next Generation Installation & User's Instructions page 58

DCN Next Generation | Installation and User Instructions | Central Devices
alone Camera Control software module (refer to the
User Manual of the LBB4162 stand-alone Camera
Control software module).
11 Disconnect the temporary PC from the central
control unit.
12 Connect the AutoDome video camera to the central
control unit (refer to figure 8.18).
9 pole D-type
(male)
DCD 1
RxD 2
TxD 3
DTR 4
SG 5
DSR 6
RTS 7
CTS 8
RI 9
DCN-CCU
figure 8. 1 8: DCN-CCU to AutoDome
8.9.3 Video switcher without a PC
8.9.3. 1 Overview
Refer to figure 8.19 for an overview of a system without
a PC and camera control through a video switcher.
Video cameras
ALLEGIANT Video Systeem
RS232
DCN-CCU
figure 8. 1 9: Video switcher without a PC
8.9.3.2 Requirements
These are the requirements for a system with camera
control through a video switcher without a PC:
• Video cameras (refer to the DCN Next Generation
Data Brochure for recommended video cameras).
• Allegiant video switcher with keyboard (refer to the
DCN Next Generation Data Brochure for
recommended video switchers).
Bosch Security Systems | 2007-02 | 9922 141 70525
Terminal
1 SG
2 TxD
3 RxD
4 +BP
5 -BP
6 SHLD
7 +BP
8 -BP
AutoDome
Power
Code Out
Alarm
Status
Battery Low
Allegiant Video display
• Video displays (refer to the DCN Next Generation
Data Brochure for recommended video displays).
• Central control unit
• Temporary PC with two serial ports.
• LBB4162 Stand-alone Camera Control software
module for systems without a PC.
8.9.3.3 Installation
1 Set the protocol for serial port 2 to camera control
(refer to section 8.3.2).
2 Set the baudrate for serial port 2 to 19.2 k
(refer to section 8.3.2).
3 Connect COM 1 of the temporary PC to the central
control unit that is used to control video cameras
(refer to figure 8.20).
Note
Refer to section 8.5.8 for maximum cable
lengths.
9 pole D-type
(female)
DCD 1
RxD 2
TxD 3
DTR 4
SG 5
DSR 6
RTS 7
CTS 8
RI 9
PC
figure 8.20: PC to DCN-CCU
4 Connect COM 2 of the temporary PC to the serial
port of the Allegiant video switcher (refer to figure
8.21). The baudrate of the connection must be 19.2k.
en | 58
9 pole D-type
(male)
1 DCD
2 RxD
3 TxD
4 DTR
5 SG
6 DSR
7 RTS
8 CTS
9 RI
DCN-CCU