Camera Control Configuration - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Central Devices
8.9

Camera control configuration

8.9.1 Introduction
The central control unit can automatically point video
cameras in the direction of the delegate or chairman
that speaks.
You can connect camera(s) as follows:
• Direct camera control in a system without a PC.
• Camera control through a video switcher in a system
without a PC.
• Direct camera control in a system with a PC.
• Camera control through a video switcher in a system
with a PC.
8.9.2 Direct camera control without a
PC
8.9.2. 1 Overview
Refer to figure 8.16 for an overview of a system with
direct camera control without a PC.
DCN-CCU
figure 8. 1 6: Direct camera control without a PC
8.9.2.2 Requirements
These are the requirements for a system with direct
camera control without a PC:
• AutoDome video camera (refer to the DCN Next
Generation Data Brochure for recommended video
cameras).
• Video display (refer to the DCN Next Generation
Data Brochure for recommended video displays).
• Central control unit.
• Temporary PC with at least one serial port.
• LTC5136 Autodome Controller.
Bosch Security Systems | 2007-02 | 9922 141 70525
AutoDome
Video display
• LBB4162 Stand-alone Camera Control software
module for systems without a PC.
8.9.2.3 Installation
1 Connect a video display to the video output of the
AutoDome video camera.
2 Connect the LTC5136 AutoDome Controller to the
AutoDome video camera.
3 Set the pre-positions of the AutoDome video camera
with the AutoDome Controller.
4 Make sure that all pre-positions of the AutoDome
video camera are correct.
5 Disconnect the LTC5136 AutoDome Controller from
the AutoDome video camera.
6 Set the protocol for serial port 2 of the central
control unit to camera control (refer to section 8.3.2).
7 Set the baudrate for serial port 2 of the central
control unit to 9.6k (refer to section 8.3.2).
8 Connect the serial port of the temporary PC to the
serial port 2 of the central control unit
(refer to figure 8.17).
Note
Refer to section 8.5.8 for maximum cable
lengths.
9 pole D-type
(female)
DCD 1
RxD 2
TxD 3
DTR 4
SG 5
DSR 6
RTS 7
CTS 8
RI 9
PC
figure 8. 1 7: PC to DCN-CCU
9 Install the LBB4162 stand-alone Camera Control
software module in the temporary PC (refer to the
DCN Next Generation Software Installation
Instructions).
10 Attach the pre-positions of the AutoDome video
camera to the seat numbers with the LBB4162 stand-
en | 57
9 pole D-type
(male)
1 DCD
2 RxD
3 TxD
4 DTR
5 SG
6 DSR
7 RTS
8 CTS
9 RI
DCN-CCU