Bosch DCN Next Generation Installation & User's Instructions page 223

DCN Next Generation | Installation and User Instructions | Installation Devices
4 Connect the power cable to a locally approved mains
power supply.
Caution
Make sure that the mains power supply is
connect to a ground. Electrical discharges from
the mains power supply can kill you.
34.5.2 DCN
Connect the extension power supply to the system with
the DCN cable (refer to figure 34.6). You can use the
DCN trunk socket to make a loop-through with the
extension power supply.
I n
O u t
figure 34.6: DCN trunk
The DCN trunk socket has a red LED that comes on if
there is an overload (refer to section 1.6.4).
table 34.3: DCN trunk connections
Number of connections:
1x DCN socket
1x DCN cable (2 m) with plug
Location:
Rear side
Power supply:
max. 1x 85 W
Bosch Security Systems | 2007-02 | 9922 141 70525
Tr un
k
Ta p-
of f
In
O ut
O ut
O ut
T a p
- o f f
O u t
34.5.3 DCN tap-offs
With the DCN tap-off sockets, you can make tap-offs in
the DCN (refer to figure 34.7).
T a p
- o f f
O u t
O u t
figure 34.7: DCN tap-offs
Each DCN tap-off socket has a red LED that comes on
if there is an overload (refer to section 1.6.4).
table 34.4: DCN tap-off connections
Number of connections:
2x DCN socket
Location:
Rear side
Power supply:
max. 2x 85 W
en | 223
Tr un
k
Ta p-
of f
In
O ut
O ut
O ut