Bosch DCN Next Generation Installation & User's Instructions page 247

DCN Next Generation | Installation and User Instructions | Installation Devices
12 Put one of the bare, copper wires into the contact
area of the socket contact. Close the crimping tool to
crimp the socket contact onto the copper wire (refer
to figure 45.14).
figure 45. 1 4: Crimping a socket contact (2)
13 Repeat steps 11 and 12 for the other bare copper
wire. Refer to figure 45.15 to see the result of this
part of the cable-connector mounting procedure.
A
figure 45. 1 5: Mounted socket contacts
Bosch Security Systems | 2007-02 | 9922 141 70525
45.4.7 Remove the sheath from the
optical fibers
Proceed as follows:
14 Put the plastic optical fibers into the POF
cutter/stripping tool (tool 6). The optical fiber that is
to be cut must be put in the small guide hole. The
other optical fiber must be put in the large guide
hole (refer to figure 45.16). Push the cable until the
crimping bush is against the stop (refer to figure
45.17).
figure 45. 1 6: Cutting a fiber (1)
B
figure 45. 1 7: Cutting a fiber (2)
en | 247