Bosch DCN Next Generation Installation & User's Instructions page 250

DCN Next Generation | Installation and User Instructions | Installation Devices
26 Crimp the ferrules on the sheath using the crimping
tool (tool 3, refer to figure 45.25). Refer to figure
45.26 for the result of this part of the cable-connector
assembly procedure.
figure 45.25: Crimping ferrules (3)
A
figure 45.26: Ferrules on fibers
Bosch Security Systems | 2007-02 | 9922 141 70525
45.4.9 Assemble the connector
Before you start to assemble the connector, the copper
wires and the plastic optical fibers for must be correctly
put in the connector. The copper wires will be attached
to the upper part of the connector, the optical fibers will
be attached to the lower part of the connector (refer to
figure 45.27).
figure 45.27: Front view of connector
table 45.3: Optical network connector details
Pin
B
E1
E2
O1
O2
Refer to the wiring diagram (figure 45.28) and figure
45.29 and figure 45.30.
figure 45.28: Wiring diagram
Note
When replacing a connector, always first check
the wiring in the connector at the other end.
E1 E2
O1 O2
Signal
+48V(DC)
GND
Data
Data
RED
E1
BROWN
E2
O1
O2
BLACK (2x)
en | 250
Wire
Copper
Copper
Optical fiber
Optical fiber
E1
E2
O1
O2