Lbb4157/00 Chip Card Encoder; Introduction; Installation; Operation - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Peripheral Devices
48 LBB4157/00 Chip Card
Encoder
48. 1

Introduction

With the LBB4157/00 Chip Card Encoder and the
ID-Card Encoder software module, you can configure
DCN-IDCRD Chip Cards (refer to chapter 49).

48.2 Installation

Caution
Before you install the chip card encoder,
disconnect the PC from the mains power supply.
Electrical discharges from the mains power
supply can kill you.
To connect the chip card encoder to a PC:
1 Disconnect the keyboard from the PC.
2 Connect the chip card encoder (1) to the PC with the
plug of the serial cable (2).
3 Connect the chip card encoder (1) to the PC with the
PS/2 plug (3).
4 Connect the keyboard to the PS/2 socket (4) of the
chip card encoder.
1
figure 48. 1 : Chip card encoder
Bosch Security Systems | 2007-02 | 9922 141 70525
2 3
4

48.3 Operation

Note
Refer to the applicable Software User Manual
for instructions that tell you how to operate the
ID-Card Encoder software module.
en | 269