Operation - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Installation Devices
5 Push the Pin Mold (G) into the Lower Metal Sleeve
(H) until they lock.
6 Push the three metal tabs on the Lower Metal Sleeve
(H) into the notches in the Pin Mold (G).
7 Crimp the 'U' section of the Lower Metal Sleeve (H)
onto the Cable (A).
8 Attach the Plastic Ring Guide (E) to the Lower Metal
Sleeve (H) and engage the plastic arms into the
correct slots in the sides of the sleeve.
9 Attach the Top Metal Cover (F) to Lower Metal
Sleeve (H). Be sure to align all tabs. Make sure that
the cover is attached correctly.
10 Push the Metal Spring (D) to the Top Metal Cover
(F)/Lower Metal Sleeve (H) assembly. This helps to
hold the assembly together.
11 Push the Strain Relief (B)/Plastic Enclosure (C)
assembly to the Top Metal Cover (F)/Lower Metal
Sleeve (H) assembly. Align the two assemblies as
shown in the drawing. Make sure that the Metal
Spring (D) stays in place and does not bend during
assembly. A large force can be necessary to attach
the two assemblies together.
12 Make sure that the Strain Relief (B)/Plastic Enclosure
(C) assembly is locked to the Top Metal Cover
(F)/Lower Metal Sleeve (H) assembly. The two
assemblies should not be able to be pulled apart.
13 Align the new assembly with the Plastic Coupling (I)
shown in the drawing. Push assembly into Plastic
Coupling (I) until it locks to the Plastic Coupling.
The connector assembly is complete.
Bosch Security Systems | 2007-02 | 9922 141 70525
41.6

Operation

The two LEDs on the network splitter give information
about the condition of the network splitter.
table 41.5: Status LEDs
Green Yellow
(Power) (Fault)
Off Off
Off On
On Off
en | 234
Condition
The network splitter does
not receive any power.
There is no optical
network available or there
is a fault in the optical
network.
The network splitter
functions correctly.