Bosch DCN Next Generation Installation & User's Instructions page 245

DCN Next Generation | Installation and User Instructions | Installation Devices
45.4.4 Crimp the bush
Do as follows:
7 Put the cable end through crimping bush to the end
of the outer sheath.
Note
The crimping tool (tool 3) makes the circular
shape of the cable cross-section and the
crimping bush at the end of the outer sheath
into a hexagonal shape.
Before you crimp the bush, make sure that both
plastic optical fibers are parallel to a flat side of
the hexagonal cross-section (refer to figure
45.8).
R B
B R
figure 45.8: Cross-section transformation
Bosch Security Systems | 2007-02 | 9922 141 70525
B
R
A
R = Red
B = Brown
A
8 Use the crimping tool (tool 3, refer to figure 45.9) to
attach the crimping bush to the outer sheath. The
crimping bush stops the cable from rotating in the
connector.
figure 45.9: Crimping the bush
45.4.5 Remove the ends of the copper
wires
Do as follows:
9 Hold the crimping bush in position I with the
stripping tool. Cut the copper wires at position II
B
(refer to figure 45.10) with the cable cutter (tool 2).
figure 45. 1 0: Cutting a copper wire
en | 245
I
II