Remote Controls - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Peripheral Devices
47.6

Remote controls

You can use the parallel inputs and parallel outputs as
remote controls. For example, to switch on lamps, open
doors or close curtains in the room.
Note
The parallel inputs and parallel outputs are also
available on a 20-pole connector (refer to table
47.9).
All parallel inputs and parallel outputs form pairs. For
example, parallel input U00 controls parallel outputs
D00.
table 47.9: Parallel inputs and outputs
Parallel inputs
Pad Pin
VC+ 1
U00 2
U01 3
U02 4
U03 5
U04 5
U05 7
U06 8
U07 9
GND 10
VC+ 11
U08 12
U09 13
U10 14
U11 15
U12 16
U13 17
U14 18
U15 reserved
GND 20
Bosch Security Systems | 2007-02 | 9922 141 70525
Parallel outputs
Pad Pin
VC+ 1
D00 2
D01 3
D02 4
D03 5
D04 5
D05 7
D06 8
D07 9
GND 10
VC+ 11
D08 12
D09 13
D10 14
D11 15
D12 16
D13 17
D14 18
D15 reserved
GND 20
The parallel inputs do not only control the associated
parallel output on the same data distribution board.
They also control the associated parallel outputs on all
other data distribution boards that are:
• In the active mode.
• In the passive mode and do not have address 253,
254 or 255.
Note
Do not use a parallel output for more than one
purpose.
For example, parallel input D00 of a distribution board
does not only control parallel output U00 of the same
data distribution board. It also controls all the parallel
output U00 of all the other data distribution boards that
are in the active mode or in the passive mode and do
not have address 253, 254 or 255.
en | 265