Bosch DCN Next Generation Installation & User's Instructions page 59

DCN Next Generation | Installation and User Instructions | Central Devices
9 pole D-type
(female)
DCD 1
RxD 2
TxD 3
DTR 4
SG 5
DSR 6
RTS 7
CTS 8
RI 9
PC
figure 8.21: PC to Allegiant
5 Connect a video display to the video output of the
Allegiant video switcher.
6 Install the LBB4162 Camera Control software
module in the temporary PC (refer to the DCN Next
Generation Software Installation Instructions).
7 Start the LBB4162 Camera Control software module
(refer to the User Manual of the LBB4162 Camera
Control software module).
8 Set the pre-positions of the video cameras with the
keyboard of the Allegiant video switcher.
9 Make sure that all pre-positions of all video cameras
are correct.
10 Attach the pre-positions of the video cameras to the
seat numbers with the LBB4162 Camera Control
software module.
11 Disconnect the temporary PC from the central
control unit and the Allegiant video switcher.
12 Connect the central control unit to the Allegiant
video switcher (refer to figure 8.22).
9 pole D-type
(male)
DCD 1
RxD 2
TxD 3
DTR 4
SG 5
DSR 6
RTS 7
CTS 8
RI 9
DCN-CCU
figure 8.22: Central control unit to video switcher
Bosch Security Systems | 2007-02 | 9922 141 70525
9 pole D-type
(male)
1 SG
2 RxD
3 TxD
4 CTS
5 RTS
6 n.c.
7 SG
8 n.c.
9 n.c.
Allegiant
8.9.4
8.9.4. 1
Refer to figure 8.23 for an overview of a system with
direct camera control with a PC.
figure 8.23: Direct camera control with a PC
8.9.4.2
These are the requirements for a system with direct
camera control with a PC:
• AutoDome video camera (refer to the DCN Next
Generation Data Brochure for recommended video
cameras).
• Video display (refer to the DCN Next Generation
Data Brochure for recommended video displays).
• Central control unit
9 pole D-type
• PC with at least one serial port.
(male)
• LTC5136 Autodome Controller.
1 SG
• LBB4188 Camera Control software module.
2 RxD
8.9.4.3
3 TxD
4 CTS
5 RTS
6 n.c.
7 SG
8 n.c.
9 n.c.
Allegiant
1 Connect a video display to the video output of he
AutoDome video camera.
Note
When you make the cable that figure 8.22
shows, mark the ends of the cable with 'CCU'
and 'Allegiant'. This makes sure that you connect
the cable in the correct direction. When you
connect the cable in the incorrect direction, the
central control unit cannot send data to the
Allegiant video switcher.
Direct control with a PC
Overview
Port 1
PC DCN-CCU
Requirements
Installation
Note
Refer to section 8.5.8 for maximum cable
lengths.
en | 59
AutoDome
Port 2
Video display