Lbb4114/00 Trunk Splitter; Introduction; Controls, Connectors And Indicators; Installation - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Installation Devices
35 LBB4114/00 Trunk
Splitter
35. 1

Introduction

Use the LBB4114/00 Trunk Splitter to divide the DCN
trunk.
35.2 Controls, connectors and
indicators
The trunk splitter (refer to figure 35.1) contains:
1 DCN socket (tap-off 1) - Makes a tap-off in the
DCN (refer to section 35.4). The socket regenerates
the DCN signal.
2 DCN socket (tap-off 2) - Makes a tap-off in the
DCN (refer to section 35.4). The socket regenerates
the DCN signal.
3 DCN cable - Connects the trunk splitter in the
trunk of the DCN (refer to section 35.4).
4 DCN socket (trunk) - Makes a loop-through in
the DCN with the trunk splitter (refer to section
35.4). The socket does not regenerate the DCN
signal.
1
4
figure 35. 1 : Top and side views
Bosch Security Systems | 2007-02 | 9922 141 70525

35.3 Installation

You can install the trunk splitter on a flat surface (refer
to figure 35.2). Use the lid of the trunk splitter to fix the
the DCN cables.
figure 35.2: Installation
table 35. 1 : Physical characteristics
Dimensions (h x w x d):
35 x 49 x 140 mm
Weight:
approximately 300 g

35.4 External connections

Connect the trunk splitter to the DCN with the DCN
cable. You can use the DCN trunk socket to make a
loop-through with the trunk splitter. With the DCN
2 tap-off sockets, you can make tap-offs in the DCN.
.
1 tap-off
3
4
figure 35.3: DCN
table 35.2: DCN connection
Number of connections:
3x DCN socket
1x DCN cable (2 m) with plug
Location:
Front and rear sides
Power consumption:
1.3 W (LBB4114/00)
1.4 W (LBB4115/00)
en | 224
tap-off 2
trunk
3