Configuration - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Central Devices
3 Set the value of the parameter in the menu item to
Yes. The addresses of all active devices in the DCN
are erased. All LEDs on all active devices in the
DCN come on.
4 Push the microphone button of each active device in
the DCN. When the central control unit gives an
address to the active device, the LEDs of the active
device go off.
Note
Do not push more than one microphone button
at the same time. The central control unit cannot
give addresses to more than one active device
at the same time.
Note
The DCN-FVU Voting Units do not have a
microphone button. Push voting button 3 to give
an address to a voting unit.
Note
You can also give an address to a DCN-DDI
Dual Delegate Interface with voting button 3 of a
connected DCN-FV Voting Panel.
Bosch Security Systems | 2007-02 | 9922 141 70525
8.7.3 Devices
You can also do the initialization of active devices that
are added to the system after you did the initialization of
the system.
Note
Use a paperclip or similar device to push the
de-init switch. Do not use a sharp object,
otherwise you might damage the de-init switch.
• Push the de-init switch of the active device for less
than half a second to erase the address of the active
device.
• Push and hold the de-init switch of the active device
for more than one second to erase the address and
do the initialization at the same time.
8.8

Configuration

8.8.1 Microphone modes
8.8. 1 .1 Introduction
Select the microphone mode with the 1 Mic. Mode
menu item (refer also to section 8.10.5). You can also set
the maximum number of enabled delegate
microphones.
Note
In systems without a control PC, the maximum
number of enabled chairman microphones is 15.
en | 52