Installation; External Connections - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Flush-mounted Devices
26.2.2 Bottom side
The bottom side of the voting panel (refer to figure 26.3)
contains:
4 External contact plug - Connects the voting
panel to an external contact (refer to section 26.4.2).
5 Solder spot - Configures the external contact plug
(refer to section 26.4.2).
6 RJ11 sockets - Connect the voting panel to the
DCN-DDI Dual Delegate Interface and the
DCN-FMICB Microphone Control Panel.
Note
The two RJ11 sockets are the same. There is not
a special RJ11 socket for the dual delegate
interface or the microphone control panel.
5
4
figure 26.3: Bottom view
Bosch Security Systems | 2007-02 | 9922 141 70525
6

26.3 Installation

The voting panel is a flush-mounted device. Refer to
chapter 19 for the installation procedures.
table 26.2: Physical characteristics
Dimensions (h x w x built-in depth):
• 40 x 100 x 80 mm (DCN-FVCRD)
• 40 x 100 x 50 mm (DCN-FV)
Weight:
• 104 g (DCN-FVCRD)
• 81 g (DCN-FV)
You can install the voting panel in a DCN-TTH
Tabletop Housing (refer to chapter 31).

26.4 External connections

26.4.1 Dual delegate interface
A Cat-4 cable with RJ11 plugs is supplied with the
panel. Use this cable to connect the panel to the
DCN-DDI Dual Delegate Interface (refer to section 21.4
and section 21.6).
table 26.3: Power consumption
Power consumption:
• 0. 1 5 W (DCN-FVCRD)
• 0. 1 0 W (DCN-FV)
en | 184