Bosch DCN Next Generation Installation & User's Instructions page 47

DCN Next Generation | Installation and User Instructions | Central Devices
4 Connect the power cable to a power supply.
Caution
Make sure that the mains power supply is
grounded. Electrical discharges from the mains
power supply can kill you.
8.5.2 DCN
Connect the trunk of the DCN to the DCN sockets of
the central control unit (refer to figure 8.5).
LED
figure 8.5: DCN
Each DCN socket has a red LED that comes on if there
is an overload (refer to figure 8.5 and section 2.5.4).
table 8. 1 0: DCN connection
Number of connections:
2x DCN socket
Location:
Rear side
Power supply:
max. 65 W (refer to figure 1. 1 )
Bosch Security Systems | 2007-02 | 9922 141 70525
8.5.3 Optical network
Connect the trunk of the optical network to the optical
network sockets of the central control unit with optical
network cables (refer to figure 8.6).
LED
figure 8.6: Optical network
Each optical network socket has a red LED that comes
on if there is an overload (refer to figure 8.6 and section
2.5.4).
table 8. 1 1: Optical network connections
Number of connections:
2x proprietary sockets
Location:
Rear side
Nodes:
2
Power supply:
0 W when connected to a DCN-NCO
Max. 65 W when used without a DCN-NCO
(refer to figure 2. 1 )
en | 47