Installing And Authorizing Simatic Step 7 - Siemens SINUMERIK 810D Commissioning Manual

Connection via TCP/IP
A WINS server can be configured using TCP/IP. The DNS server and DNS extension are
omitted. The WINS and gateway entries are also configurable with DHCP, and are
displayed.
IP addresses can now also be entered with "." as a separator.
Note
WINS cannot be preassigned with "0 0 0 0", or the connection to subnets via DHCP will not
work.
Post-installing Windows components
Requirement: You will need the Windows XP Recovery CD and Service Pack 2 to post-
install individual components. Software, which may be required for post-installation if third-
party applications have been installed, is also stored at D:\Updates\Base.
1. \MDAC21.SP2: Data Access Components V2.1 SP2 (Y2K-compatible)
2. \SP6a: Windows NT 4.0 Service Pack 6a
3. \DRIVERS\SYSTEM.INI : Keyboard table (must be copied to E:\Windows if required).
4. \DDEFIX
5. \VBFIX : Visual Basic Hot fix
3.3.1

Installing and authorizing SIMATIC STEP 7

Overview
SIMATIC STEP 7 V5.3 SP2 can also be installed on the PCU.
Delivery item:
Components:
Type of delivery:
System requirements:
PCU Basesoftware (IM6)
Commissioning Manual, 10/2006, 6FC5397-0DP10-0BA0
The installation path to be entered for "Install New Fix" is:
D:\Updates\Base\DDEFIX\hotfix.inf
3.3 Network operation with the Service desktop
SIMATIC STEP 7 V5.3 SP2
SIMATIC STEP 7 V5.3 SP2 and
Add-on for SINUMERIK 810D/840D/840D sl/840Di sl
2 installation CDs
PCU basic software V8.0 or higher
A network connection or a connection to a CD-ROM drive is required.
Recommendation: Mouse port
Installing software and network operation
3-19