Siemens SINUMERIK 810D Commissioning Manual page 59

Changing the installation directory on the connected drive
If the software to be installed is located in a subdirectory of the shared directory, you can
change the installation directory as follows.
1. Press key <4>: Change Install Directory
Your Choice [1, 4, 5, 9]?
2. Press key <5> to start the installation:
3. The system checks whether the D:\INSTALL directory already contains files.
4. When you exit the menu, you are prompted to confirm whether you want to save the
PCU Basesoftware (IM6)
Commissioning Manual, 10/2006, 6FC5397-0DP10-0BA0
An input screen appears in which you can specify the installation directory (e.g.,
HMI_INST):
---------------------------------------------------------------------------------------------------------------
Old Install Directory: G:\
New Install Directory: G:\HMI_INST
---------------------------------------------------------------------------------------------------------------
You can now start the transfer:
PLEASE SELECT
1 Manage Network Drives
4 Change Install Directory
5 Install from G:\HMI_INST
9 Back to Previous Menu
– The system starts the transfer from the PG/PC to the PCU.
– The PCU is automatically restarted (warm restart) after the transfer.
– Select "SINUMERIK" in the Boot Manager. The transferred software is now installed,
menu-assisted in some cases.
Setup installs the program: Installation via a network connection is now complete.
Notice
If the software cannot be copied to the D:\INSTALL directory on the PCU, then the
system cannot start the installation.
network connection parameter settings.
Installing software and network operation
3.1 Installing software and software update
3-11