Installing/Mounting - Siemens SINAMICS G120P Hardware Installation Manual

Installing/Mounting

To ensure the safe operation of the equipment, it must be installed and commissioned by
qualified personnel in full compliance with the warnings laid down in this manual.
Take particular note of the general and regional installation and safety regulations
regarding work on dangerous voltage installation (e.g. EN 61800-5-1) as well as the
relevant regulations regarding the correct use of tools and personal protective equipment
(PPE).
General rules for the environmental protection of the Power Modules
To ensure that the power module is installed in the correct environmental conditions, please
ensure that you adhere to the following guidelines:
● The Power Module FSA ... FSF is designed for IP55 protection. It is protected against
● Although the Power Module is protected against the ingress of water, this is dependent
● Keep the Power Module free from dust and dirt
● Keep the Power Module away from solvents and chemicals
● Keep the Power Module within the maximum and minimum operating temperatures
Power Module PM230 IP55
Hardware Installation Manual, 2010-07-02, A5E02923635A AB
WARNING
dust-limited ingress (no harmful deposit) and against low pressure jets of water from all
directions (although limited ingress is permitted).
on the correct fitting of any seals, including the seals necessary for the fitting of an
operator panel
3
21