2.1
1st step: Installing the IM 151-7 CPU (ET 200S) and
S7-300
Se-
Description
quence
1
Install the S7-300 as described in Installation Manual for Automation System S7-300, Setting
Up.
2
If you want to operate the IM 151-7 CPU using a dedicated power supply, hang the PS in the
mounting rail of the S7-300 and push in until it engages.
3
Hang the IM 151-7 CPU in the mounting rail and push in until it engages.
4
Hang the TM for the PM in the mounting rail to the right of the IM 151-7 CPU and push in until
it engages.
5
Push the TM to the left until it engages audibly in the IM 151-7 CPU.
6
Repeat points 3 and 4 for two TMs for the electronics modules and finally for the terminating
module (does not engage in the mounting rail).
7
Push the PM into the appropriate TM until it engages.
8
Push the DI into the free TM on the left until it engages.
9
Push the DO into the last free TM until it engages.
10
Insert the micro memory card into the IM 151-7 CPU (must be installed otherwise the system
will not work). A micro memory card with unknown content should be erased beforehand at the
programming device.
Figure 2-1
ET 200S IM 151-7 CPU Interface Module
A5E00058783-04
SF
BF
ON
FRCE
RUN
STOP
Installing the IM 151-7 CPU (ET 200S)
Getting Started
2-3