Siemens SINUMERIK 810D Commissioning Manual page 39

Executing an HMI program
The HMI program can also be started from the service desktop.
Ending an HMI program
When an HMI program started from the service desktop is exited, you are returned to the
service desktop.
Saving the service desktop (default)
The settings on the service desktop (e.g. arrangement of the links on the service desktop)
are not saved when you log off. A service technician should always find the same starting
condition on the service desktop, not the settings from a previous session.
Saving the settings of the service Desktop
This behavior can be changed by making an entry in the registry. The following settings can
be saved via this registry entry:
● Positions of open windows
● Size and position of the task bar
● Moving and deleting links
Key:
Value:
Date:
Init data:
Default data:
The key is effective for all service users and other users.
Links on the service desktop are always saved, irrespective of the registry entry.
Note
Application windows that are still open before logging out, must be closed by the setting
"Save settings" before exiting the service desktop. Otherwise, these application windows will
briefly be displayed and then closed again during a restart immediately before the HMI
program starts.
PCU Basesoftware (IM6)
Commissioning Manual, 10/2006, 6FC5397-0DP10-0BA0
HKLM\SOFTWARE\Siemens\SINUMERIK\Basic software\ <version>\HMI
Manager
SaveSINDesktopSettings (DWORD)
1 (the settings are saved) or
0 (the settings are NOT saved)
- Value is not created by the basic software -
0 (if entry is not available/readable)
Configuring the system
2.3 User-specific settings during boot up
2-15