Gearshift Shaft / Gearshift Cam Plate Removal And Installation (Lt-F400 - Suzuki LT-A400 Service Manual

5B-11 Manual Transmission:
Gearshift Shaft / Gearshift Cam Plate Removal
and Installation (LT-F400/F)
Removal
1) Drain engine oil
2) Remove the clutch assembly. Refer to "Clutch
Removal and Installation (LT-F400/F) in Section 5C
(Page 5C-3)".
3) Remove the gearshift cam plate guide (1).
4) Remove the gearshift shaft assembly (2) and
gearshift cam plate (3).
3
5) Remove the gearshift shaft stopper (4).
B827H15206011
1
I827H1520022-01
2
I827H1520023-01
4
I827H1520024-01
6) Remove the spring (5) and gearshift cam stopper
(6).
5
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Apply a small quantity of thread lock to the thread of
gearshift cam stopper bolt.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
• Tighten the nut (1) to the specified torque.
NOTE
Hook the return spring end to the stopper.
Tightening torque
Gearshift cam stopper nut (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
6
I827H1520025-01
I827H1520026-01
1
(a)
I827H1520027-01