Table of Contents
Advertisement
Insert the universal joint to the bearing and check the
play by turning the universal joint, as shown. If excessive
play is noted, replace the bearing with a new one.
Front Output Shaft Related Parts Inspection (LT-
A400F, LT-F400F)
Refer to "Front Output Shaft Disassembly and Assembly
(LT-A400F, LT-F400F) (Page 3D-10)".
Front Output Shaft (LT-A400F, LT-F400F)
Inspect the front output shaft for distortion.
If distortion is found, replace the front output shaft with a
new one.
Front Output Shaft Oil Seal (LT-A400F, LT-F400F)
Visually inspect the oil seal for damage, with particular
attention given to the lip.
Replace the oil seal that shows indications of leakage.
Front Output Shaft Bearing (LT-A400F, LT-F400F)
Inspect the front output shaft bearing for abnormal noise
and smooth rotation.
Replace the bearing if there is anything unusual.
I827H1320048-01
Drive Bevel Gear Removal and Installation (LT-
B827H13406020
A400/F)
Removal
1) Remove the engine assembly from the frame. Refer
to "Engine Assembly Removal in Section 1D
(Page 1D-6)".
2) Remove the engine top side. Refer to "Engine Top
Side Disassembly in Section 1D (Page 1D-10)".
3) Separate the crankcase. Refer to "Engine Bottom
Side Disassembly in Section 1D (Page 1D-34)".
4) Using a chisel, unlock the nut.
I827H1340090-01
5) Hold the transfer driven gear with the special tool
and remove the driven bevel gear nut.
Special tool
holder)
I827H1340060-02
Propeller Shafts:
(A): 09920–53740 (Clutch sleeve hub
3D-13
I827H1340061-01
B827H13406021
I827H1340062-01
Advertisement
Chapters
Table of Contents
