Suzuki LT-A400 Service Manual page 346

3D-14 Propeller Shafts:
(A)
6) Remove the washer (1) and drive bevel gear (2).
7) Remove the shim (3).
1
2
8) Remove the transfer output shaft (4) with a plastic
mallet.
CAUTION
!
• Do not disassemble the transfer output
shaft.
• The transfer driven gear and transfer
output shaft is available only as an
assembly.
Installation
Install the drive bevel gear in the reverse order of
removal. Pay attention to the following points:
NOTE
Apply engine oil to each rotating part before
reassembling.
I827H1340063-01
3
I827H1340064-01
4
I827H1340065-02
• Install the transfer output shaft assembly (1) with a
plastic mallet.
1
• Install the shim (2), drive bevel gear (3) and washer
(4).
2
• Hold the transfer driven gear with the special tool and
tighten the drive bevel gear nut to the specified
torque.
CAUTION
!
The removed drive bevel gear nut must be
replaced with a new one.
Special tool
(A): 09920–53740 (Clutch sleeve hub holder)
Tightening torque
Drive bevel gear nut (a): 100 N·m (10.0 kgf-m,
72.5 lb-ft)
(A)
I827H1340066-01
4
3
I827H1340067-01
(a)
I827H1340068-01