Suzuki LT-A400 Service Manual page 413

• Install the pins and rollers.
• Install the spring seat (4) with aligning the hole "A"
with the hole "B".
4
• Install the spring (5) and spring plate (6) with hooking
the spring ends with the holes "C" and "D".
5
"C"
I827H1510040-01
"A"
"B"
I827H1510041-01
6
"D"
5
I827H1510042-01
Automatic Transmission:
• Compress the spring with the special tool.
Special tool
(B): 09922–31430 (Clutch spring
compressor)
NOTE
Make sure to insert the spring end "E" into
the slot "F" of the special tool as shown in
the figure.
• Tighten the movable driven face ring nut (7)
temporarily.
"E"
• Remove the special tool from the movable driven face
assembly.
• Tighten the movable driven face ring nut to the
specified torque with the special tools.
Tightening torque
Movable driven face ring nut: 100 N·m (10.0 kgf-
m, 72.5 lb-ft)
Special tool
(C): 09917–23711 (Ring nut wrench)
(D): 09924–54520 (Fixed driven face holder)
5A-14
(B)
I827H1510043-01
"F"
7
I827H1510044-01
(C)
(D)
I827H1510045-01