Setting The Time Zone - Edge-Core ECS4510-12PD Web Management Manual

12-port gigabit ethernet layer 2 switch

Hide thumbs Also See for ECS4510-12PD:

Table of Contents

| Basic Management Tasks

Setting the System Clock

Setting the Time Zone

Use the System > Time (Configure Time Server) page to set the time zone. SNTP

uses Coordinated Universal Time (or UTC, formerly Greenwich Mean Time, or GMT)

based on the time at the Earth's prime meridian, zero degrees longitude, which

passes through Greenwich, England. To display a time corresponding to your local

time, you must indicate the number of hours and minutes your time zone is east

(before) or west (after) of UTC. You can choose one of the 80 predefined time zone

definitions, or your can manually configure the parameters for your local time zone.

The following parameters are displayed:

Name – Assigns a name to the time zone. (Range: 1-30 characters)

Hours (-12 - 13) – The number of hours before/after UTC. The maximum value

before UTC is 12. The maximum value after UTC is 13.

Minutes (0-59) – The number of minutes before/after UTC.

Web Interface

To set your local time zone:

Click System, then Time.

Select Configure Time Zone from the Action list.

Set the offset for your time zone relative to the UTC in hours and minutes.

Click Apply.

Figure 20: Setting the Time Zone

Table of Contents