Table of Contents
Advertisement
Retry times – The maximum number of times to resend an inform
■
message if the recipient does not acknowledge receipt.
(Range: 0-255; Default: 3)
◆
Community String – Specifies a valid community string for the new trap
manager entry. (Range: 1-32 characters, case sensitive)
Although you can set this string in the Configure Trap – Add page, we
recommend defining it in the Configure User – Add Community page.
◆
UDP Port – Specifies the UDP port number used by the trap manager.
(Default: 162)
SNMP Version 3
◆
IP Address – IP address of a new management station to receive notification
message (i.e., the targeted recipient).
◆
Version – Specifies whether to send notifications as SNMP v1, v2c, or v3 traps.
◆
Notification Type
Traps – Notifications are sent as trap messages.
■
Inform – Notifications are sent as inform messages. Note that this option is
■
only available for version 2c and 3 hosts. (Default: traps are used)
■
Timeout – The number of seconds to wait for an acknowledgment
before resending an inform message. (Range: 0-2147483647
centiseconds; Default: 1500 centiseconds)
Retry times – The maximum number of times to resend an inform
■
message if the recipient does not acknowledge receipt.
(Range: 0-255; Default: 3)
◆
Local User Name – The name of a local user which is used to identify the
source of SNMPv3 trap messages sent from the local switch. (Range: 1-32
characters)
If an account for the specified user has not been created
automatically generated.
◆
Remote User Name – The name of a remote user which is used to identify the
source of SNMPv3 inform messages sent from the local switch. (Range: 1-32
characters)
If an account for the specified user has not been created
automatically generated.
Chapter 13
– 399 –
| Basic Administration Protocols
Simple Network Management Protocol
(page
393), one will be
(page
395), one will be
Advertisement
Chapters
Table of Contents
