Edge-Core ECS4510-12PD Web Management Manual page 56

Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
Table 4: Switch Main Menu
Menu
Configure Details
Configure Operation
CFM
Configure Global
Configure Interface
Configure MD
Add
Configure Details
Show
Configure MA
Add
Configure Details
Show
Configure MEP
Add
Show
Configure Remote MEP
Add
Show
Transmit Link Trace
Transmit Loopback
Transmit Delay Measure
Show Information
Show Local MEP
Show Local MEP Details
Show Local MIP
(Continued)
Description
Configures ring parameters
Blocks a ring port using Forced Switch or Manual Switch commands
Connectivity Fault Management
Configures global settings, including administrative status, cross-check
start delay, link trace, and SNMP traps
Configures administrative status on an interface
Configure Maintenance Domains
Defines a portion of the network for which connectivity faults can
be managed, identified by an MD index, maintenance level, and the MIP
creation method
Configures the archive hold time and fault notification settings
Shows list of configured maintenance domains
Configure Maintenance Associations
Defines a unique CFM service instance, identified by its parent MD, the
MA index, the VLAN assigned to the MA, and the MIP creation method
Configures detailed settings, including continuity check status and
interval level, cross-check status, and alarm indication signal parameters
Shows list of configured maintenance associations
Configures Maintenance End Points
Configures MEPs at the domain boundary to provide management access
for each maintenance association
Shows list of configured maintenance end points
Configures Remote Maintenance End Points
Configures a static list of remote MEPs for comparison against
the MEPs learned through continuity check messages
Shows list of configured remote maintenance end points
Sends link trace messages to isolate connectivity faults by
tracing the path through a network to the designated target node
Sends loopback messages to isolate connectivity faults by requesting a
target node to echo the message back to the source
Sends periodic delay-measure requests to a specified MEP within a
maintenance association
Shows the MEPs configured on this device
Displays detailed CFM information about a specified local MEP in the
continuity check database
Shows the MIPs on this device discovered by the CFM protocol
– 56 –
Page
422
438
442
445
449
449
449
449
449
454
454
454
454
458
458
458
460
460
460
462
464
465
467
468
470