Table of Contents
Advertisement
◆
When MAC-based, IP subnet-based, and protocol-based VLANs are supported
concurrently, priority is applied in this sequence, and then port-based VLANs
last.
Parameters
These parameters are displayed:
◆
IP Address – The IP address for a subnet. Valid IP addresses consist of four
decimal numbers, 0 to 255, separated by periods.
◆
Subnet Mask – This mask identifies the host address bits of the IP subnet.
◆
VLAN – VLAN to which matching IP subnet traffic is forwarded.
(Range: 1-4093)
◆
Priority – The priority assigned to untagged ingress traffic. (Range: 0-7, where
7 is the highest priority; Default: 0)
Web Interface
To map an IP subnet to a VLAN:
1.
Click VLAN, IP Subnet.
2.
Select Add from the Action list.
3.
Enter an address in the IP Address field.
4.
Enter a mask in the Subnet Mask field.
5.
Enter the identifier in the VLAN field. Note that the specified VLAN need not
already be configured.
6.
Enter a value to assign to untagged frames in the Priority field.
7.
Click Apply.
Figure 87: Configuring IP Subnet VLANs
– 163 –
Chapter 5
| VLAN Configuration
Configuring IP Subnet VLANs
Advertisement
Chapters
Table of Contents
