Table of Contents
Advertisement
Figure 227: LLDP MED Location CA Types
CA Type Description
26
Unit (apartment, suite)
27
Floor
28
Room
◆
Any number of CA type and value pairs can be specified for the civic address
location, as long as the total does not exceed 250 characters.
Parameters
These parameters are displayed in the web interface:
◆
CA-Type – Descriptor of the data civic address value. (Range: 0-255)
◆
CA-Value – Description of a location. (Range: 1-32 characters)
Web Interface
To specify the physical location of the attached device:
1.
Click Administration, LLDP.
2.
Select Configure Interface from the Step list.
3.
Select Add CA-Type from the Action list.
4.
Select an interface from the Port or Trunk list.
5.
Specify a CA-Type and CA-Value pair.
6.
Click Apply.
Figure 228: Configuring the Civic Address for an LLDP Interface
To show the physical location of the attached device:
1.
Click Administration, LLDP.
2.
Select Configure Interface from the Step list.
Chapter 13
(Continued)
– 359 –
| Basic Administration Protocols
Link Layer Discovery Protocol
CA Value Example
Apt 519
5
509B
Advertisement
Chapters
Table of Contents
