Configuring A List Of Name Servers - Edge-Core ECS4510-12PD Web Management Manual

Chapter 15
| IP Services
Domain Name Service
Configuring a List of
Name Servers
Use the IP Service > DNS - General (Add Name Server) page to configure a list of
name servers to be tried in sequential order.
Command Usage
◆
To enable DNS service on this switch, configure one or more name servers, and
enable domain lookup status (see
Parameters" on page
◆
When more than one name server is specified, the servers are queried in the
specified sequence until a response is received, or the end of the list is reached
with no response.
◆
If all name servers are deleted, DNS will automatically be disabled. This is done
by disabling the domain lookup status.
Parameters
These parameters are displayed:
Name Server IP Address – Specifies the IPv4 or IPv6 address of a domain name
server to use for name-to-address resolution. Up to six IP addresses can be added
to the name server list.
Web Interface
To create a list name servers:
1.
Click IP Service, DNS.
2.
Select Add Name Server from the Action list.
3.
Enter one name server at a time.
4.
Click Apply.
Figure 334: Configuring a List of Name Servers for DNS
To show the list name servers:
1.
Click IP Service, DNS.
2.
Select Show Name Servers from the Action list.
"Configuring General DNS Service
513).
– 516 –