Table of Contents
Advertisement
Figure 51: Enabling LACP on a Port
To configure LACP parameters for group members:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Aggregation Port from the Step list.
3.
Select Configure from the Action list.
4.
Click Actor or Partner.
5.
Configure the required settings.
6.
Click Apply.
Figure 52: Configuring LACP Parameters on a Port
To show the active members of a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step List.
3.
Select Show Member from the Action List.
– 121 –
Chapter 4
| Interface Configuration
Trunk Configuration
Advertisement
Chapters
Table of Contents
