Configuring An Mpls Interface - Alcatel-Lucent 7450 Manual

Configuring an MPLS Interface

Configure the label-map parameters if the interface is used in a static LSP.
To configure an MPLS interface on a router, enter the following commands:
CLI Syntax: config>router>mpls
The following displays an interface configuration example:
interface config
A:ALA-1>config>router>mpls# info
----------------------------------------------
...
...
----------------------------------------------
A:ALA-1>config>router>mpls#
7450 ESS MPLS Guide
interface
no shutdown
admin-group group-name [group-name...(up to 32 max)]
label-map
pop
swap
no shutdown
srlg-group group-name [group-name...(up to 5 max)]
te-metric value
interface "to-104"
admin-group "green"
admin-group "red"
admin-group "yellow"
label-map 35
swap 36 nexthop 10.10.10.91
no shutdown
exit
exit
no shutdown
MPLS and RSVP
Page 177