Alcatel-Lucent 7450 Manual page 659

Ethernet service switch
Table of Contents

Advertisement

If no LDP messages are exchanged for the configured time interval, the LDP session is torn down.
Keepalive timeout is usually three times the keepalive interval. To maintain the session permanently,
regardless of the activity, set the value to zero.
When LDP session is being set up, the keepalive timeout is negotiated to the lower of the two peers.
Once a operational value is agreed upon, the keepalive factor is used to derive the value of the
keepalive interval.
The no form of the command at the interface-parameters and targeted-session levels sets the
keepalive timeout and the keepalive factor to the default value.
The no form of the command, at the interface level, sets the keepalive timeout and the keepalive
factor to the value defined under the interface-parameters level.
The no form of the command, at the peer level, will set the keepalive timeout and the keepalive
factor to the value defined under the targeted-session level.
Note that the session needs to be flapped for the new args to operate.
Default
Parameters
timeout — Configures the time interval, expressed in seconds, that LDP waits before tearing down the
factor — Specifies the number of keepalive messages, expressed as a decimal integer, that should be
local-lsr-id
Syntax
local-lsr-id {system | interface | interface-name interface-name}
no local-lsr-id
Context
config>router>ldp>interface-parameters>interface>ipv4/
config>router>ldp>interface-parameters>interface>ipv6
config>router>ldp>targeted-session>peer
config>router>ldp>targeted-session>peer-template
Description
This command enables the use of the address of the local LDP interface, or any other network
interface configured on the system, as the LSR-ID to establish link LDP Hello adjacency and LDP
session with directly connected LDP peers. The network interface can be a loopback or not.
7450 ESS MPLS Guide
Context
config>router>ldp>if-params
config>router>ldp>targ-session
config>router>ldp>if-params>if
config>router>ldp>targ-session>peer
session.
Values
1 — 65535
sent on an idle LDP session in the keepalive timeout interval.
Values
1 — 255
timeout
30
40
Inherits values from interface-parameters context.
Inherits values from targeted-session context.
Generic Commands
factor
3
4
Page 659

Advertisement

Table of Contents
loading

Table of Contents