Configuring Ip And Mpls In An Overlay Network To Use A Gmpls Lsp - Alcatel-Lucent 7450 Manual

Configuring IP and MPLS in an Overlay Network to Use a GMPLS LSP

Configuring IP and MPLS in an Overlay Network to Use a
GMPLS LSP
IP and MPLS is able to use GMPLS LSPs as transport by bringing a numbered or unnumbered
IP interface to an endpoint of one or more gLSPs. This IP interface appears as any other IP
interface bound to a network port. The IP interface is bound to the GMPLS tunnel group by a
GMPLS tunnel group number configured in the port command.
The GMPLS tunnel group number must correspond to a locally configured GMPLS tunnel
group.
The following CLI tree illustrates where the GMPLS tunnel group is referenced.
config
Page 456
router
interface if-name
address a.b.c.d|ipv6-address
port gmpls-tunnel-group gmpls-tunnel-group-id
7450 ESS MPLS Guide