Alcatel-Lucent 7450 Manual page 474

GMPLS Commands
Default
no e2e-protection-type
Parameters protection-type — Specifies the end-to-end GMPLS recovery type.
encoding-type
Syntax encoding-type encoding-type
no encoding-type
Context config>router>gmpls>lsp
Description This command configures the encoding type of the payload carried by the GMPLS LSP. line is the
only supported type.
Default
no encoding-type
Parameters encoding-type — Specifies the encoding type.
generalized-pid
Syntax generalized-pid generalized-pid
no generalized-pid
Context configure>router>gmpls>lsp
Description This command configures the type of payload carried by the gLSP. Standard ethertype values are
used for packet and Ethernet LSPs (see RFC 3471). Only Ethernet (value 33) is supported in Release
13.0.
Default
no generalized-pid
Parameters generalized-pid — Specifies the name of the generalized-pid.
Page 474
Values
{unprotected | 1toN | sbr}
Default unprotected
Values
line
Default line
Values
ethernet
Default ethernet
7450 ESS MPLS Guide