Alcatel-Lucent 7450 Manual page 478

GMPLS Commands
Parameters
signal-type — Specifies the RFC 3471 name of the signal type representing the requested bandwidth
exclude-srlg
Syntax exclude-srlg group-name [group-name ... (up to 5 max)]
no exclude-srlg [group-name [group-name ... (up to 5 max)]]
Context config>router>gmpls>lsp>working-path
Description
This command specifies a list of one to five SRLG groups in the optical network which the 7x50 can
request to the UNI-N that the GMPLS LSP path should avoid by signaling it in the XRO of the RSVP
path message. Each group-name must have been defined under config>router>if-attribute>srlg-
group.
The no form of the command removes the list of SRLG groups to exclude.
Default n/a
Parameters
group-name — Specifies the name of the SRLG.
segment-protection-type
Syntax segment-protection-type protection-type
no segment-protection-type
Context config>router>gmpls>lsp>working-path
Description This command defines the requested segement recovery type for the GLSP path. This is the recovery
capability requested by the 7x50 UNI-C to the UNI-N for recovery in segments of the optical
network between ingress and egress UNI-N nodes.
The no form of this command removes the configued segement recovery, reverting to unprotected.
Default
no segment-protection-type
Parameters protection-type — Specifies the requested GMPLS segment recovery type.
Page 478
for the GMPLS LSP path.
Values
{ds0 | ds1 | e1 | ds2 | e2 | ethernet | e3 | ds3 | sts-1 | fast-ethernet | e4 | fc-0-133m |
oc-3/stm1 | fc-0-266m | fc-0-531m | oc-12/stm-4 | gige | fc-0-1062m | oc-48/stm-16
| oc-192/stm-64 | 10gige-ieee | oc-768/stm-256 | 100gige-ieee}
Values 32 characters maximum text string
Values
{unprotected | sbr | gr | sncp | prc}
Default unprotected
7450 ESS MPLS Guide